3D printed housing for the Behringer 2600 synthesizer in vintage design

D-Printed Case for the Behringer 2600 – ARP 2600 Clone in Vintage Design

The case is 3D printed in one solid piece, except for the top cover, which is attached to the side panels with four screws.

Optional Korg SQ-1 Sequencer Mount

An optional mount for the Korg SQ-1 sequencer is available. It attaches to the top cover with two screws.

The sequencer slides in from the front and is held securely in place by two built-in magnets.

An opening on the top allows access to the SQ-1’s USB port.

Dimensions

• 2600 Case: 40 cm (height) × 49 cm (width) × 19.4 cm (depth)

• 2600 Case with SQ-1 Mount: 49.5 cm (height) × 49 cm (width) × 19.4 cm (depth)

The bottom features four rubber feet that prevent slipping.

The lower part and a section of the rear panel are open to allow for better airflow and ventilation.

Available Configurations

• Variant A: 2600 Case only

• Variant B: 2600 Case + SQ-1 Mount

Custom colors are available upon request.

Installation of the Behringer 2600

Installation is quick and easy:

Slide your Behringer 2600 synthesizer from above into the side guide rails.

Optionally insert the rear panel and attach the SQ-1 mount to the top cover using the included screws.

Once the rear panel and synthesizer are in place, secure the top cover with four screws.

Included in Delivery

• 1 × 3D-printed case

• 4 × rubber feet

📦 The Behringer 2600 synthesizer, slider caps, and SQ-1 sequencer shown in the photos are not included in this offer.